20 Apr 2007 jkkroll   » (Master)

Spoka - Part II

(Continued from previous post..)

After removing the LEDs, I marked the outside of the shell to indicate where the eyes and nose were on the rubber cover. Then I modified a small prototyping board to fit into the space, aligning the eyes with the marks made previously. (Notice that the marks are on the same side of the shell as the hole for the plug. Whoops. I had to redo them on the other side)

Marking Open space inside PCB

Then wire the new pcb up, program it and install in the housing for a test (notice my chip-clip programming adapter. It’s handy)…
New Schematic Wired New PCB Step 2Red Green Blue White Mouth

Syndicated 2007-02-12 08:02:05 from robotguy.net/Blog

Latest blog entries     Older blog entries

X
Share this page