20 Apr 2007 jkkroll   » (Master)

Watson, come here. I want to see you!

I finally managed to send some data over the RF link. Somehow I managed to break the printf function, so I only saw the data on the scope as it clocked out of the transceiver on the SPI bus, but it was the correct data. Here’s a hint if you are using the NRF24L01 chip. Go to the Nordic website and make sure you have the latest datasheet. There is a step by step guide to the minimum config for enhanced shockburst mode. Once I had all of my generic SPI problems worked out, it just fell into place. Now to wrap it all up into a nice library and install it on a robot!

P.S. If the title didn’t make any sense, try here. Be sure to check out his notebook.

Syndicated 2007-02-09 16:58:00 from robotguy.net/Blog

Latest blog entries     Older blog entries

X
Share this page